From CockosWiki

Main Page > REAPER Documentation > REAPER Effects

ReaEQ is a fast, configurable, unlimited band equalizer plug-in.

Usage

Graph

You can click on any point on the graph and move it to the desired frequency/gain/reduction.

It is also possible to change only one parameter using these points on the graph.

Gain 

CTRL + Left-Click

Frequency 

ALT + Left-Click

Bandwidth (or Q) 

SHIFT + Left-Click

It is also possible to :

Display a context menu where you can add a new point, delete, enable, disable or reset the selected point 

Right-Click

Enable/disable the selected point 

Double Left-Click

You can also use the mouse wheel to change the bandwidth of the point under the cursor.

Tab

• Clicking on any tab will select that point where you can use the sliders to tune or fine-tune the values
  • You can fine-tune any slider by holding the Ctrl key while using the slider

• There are different filter modes for each band:
  • Low Shelf
  • High Shelf
  • Band
  • Lowpass: This will cut any frequency above the set value
  • Highpass: This will cut any frequency below the set value
  • Allpass: This will change the phase response of the set frequency
  • Notch: This will cut the set frequency
  • Bandpass: This will cut everything but the set frequency

Buttons

• Add band: This will add a new band to the graph
• Delete band: This will remove the current band

Main Page > REAPER Documentation > REAPER Effects