ReaEQ
From CockosWiki
(Difference between revisions)
Christophe (Talk | contribs) |
Christophe (Talk | contribs) |
||
Line 16: | Line 16: | ||
** '''Right click''': Display a context menu where you can add a new point, delete, enable, disable or reset the selected point | ** '''Right click''': Display a context menu where you can add a new point, delete, enable, disable or reset the selected point | ||
** '''Double left click''': Enable/disable the selected point | ** '''Double left click''': Enable/disable the selected point | ||
+ | * You can also use the mouse wheel to change the bandwidth of the point under the cursor. | ||
Revision as of 02:04, 1 March 2007
Main Page > REAPER Documentation > REAPER Effects
ReaEQ is a fast, configurable, unlimited band equalizer plug-in.
Contents |
Usage
Graph
- You can click on any point on the graph and move it to the desired frequency/gain. You can also use the following modifiers when clicking on a graph point:
- Ctrl+left click: Change the gain only
- Alt+left click: Change the frequency only
- Shift+left click: Change the bandwidth only
- Right click: Display a context menu where you can add a new point, delete, enable, disable or reset the selected point
- Double left click: Enable/disable the selected point
- You can also use the mouse wheel to change the bandwidth of the point under the cursor.
Tab
- Clicking on any tab will select that point where you can use the sliders to tune or fine-tune the values
- You can fine-tune any slider by holding the Ctrl key while using the slider
- There are different filter modes for each band:
- Low Shelf
- High Shelf
- Band
- Lowpass: This will cut any frequency above the set value
- Highpass: This will cut any frequency below the set value
- Allpass: This will change the phase response of the set frequency
- Notch: This will cut the set frequency
- Bandpass: This will cut everything but the set frequency
Buttons
- Add band: This will add a new band to the graph
- Delete band: This will remove the current band