From CockosWiki

Revision as of 01:29, 1 March 2007

Main Page > REAPER Documentation > REAPER Effects

ReaEQ is a fast equalizer plug-in.

Usage

Graph

• You can click on any point on the graph and move it to the desired frequency/gain. You can also use the following modifiers when clicking on a graph point:
  • Ctrl+left click: Change the gain only
  • Alt+left click: Change the frequency only
  • Shift+left click: Change the bandwidth only
  • Right click: Display a context menu where you can add a new point, delete, enable, disable or reset the selected point
  • Double left click: Enable/disable the selected point

Tab

• Clicking on any tab will select that point where you can use the sliders to tune or fine-tune the values
  • You can fine-tune any slider by holding the Ctrl key while using the slider

• There are different filter modes for each band:
  • Low Shelf
  • High Shelf
  • Band
  • Lowpass: This will cut any frequency above the set value
  • Highpass: This will cut any frequency below the set value
  • Allpass: This will change the phase response of the set frequency
  • Notch: This will cut the set frequency
  • Bandpass: This will cut everything but the set frequency

Buttons

• 'Add band': This will add a new band to the graph
• 'Delete band': This will remove the current band